image Strona Główna       image SKFAB00GBB       image ceelt smp       image Artykul1       image ArmyBeasts       image 2006 nov p3       

Odnośniki

[ Pobierz całość w formacie PDF ]

ÿþSPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL X
SKODA FABIA 00 ’! DIESEL
’!
MAKE MOD. YEAR.
ALARM/SIREN Position the compact alarms and the sirens in the engine compartment, behind the
left lateral headlamp.
POSITION
CENTRAL UNIT POSITION Position the modular systems and the modules under the left of the dashboard,
driver s side.
POWER SUPPLY + 30: connect to the pin marked  +30 located on the driving bar, under the
dashboard, driver s side.
- 31: connect with a cable terminal directly to the car body.
IGNITION WIRE + 15/54: connect to the BLACK wire located at the position nr.12 coming out of the
S4 connector, on the connectors holder bracket, on the left, under the steering
wheel.
DIRECTION INDICATORS Connect to the BLACK/GREEN wire at the position nr. 14 and to the
BLACK/WHITE wire at the position nr. 16, in the 16 way black connector, on the
connectors holder bracket, on the left, under the steering wheel.
ELECTRIC WINDOWS Comfort closing
It is necessary to set lock command wire to 24s. (VIOLET wire of the antitheft).
CENTRAL DOORS LOCKING Negative control signal
Connect to the YELLOW/BLUE wire at the position nr. 5 (nr. 2) located in the wiring
harness coming out of the violet/white connector placed behind the left lateral side.
To this wire are connected both the lock and unlock pulses (add a 180&! resistance
on the ORANGE unlock wire).
IMMOBILISATION POINT 1 Fuel pump
Cut the 0,75 mm2 BLUE/YELLOW wire located in the wiring harness coming out of
the relay marked nr. 167 placed above the connectors holder, on the left, under the
steering wheel
STARTER +50: Cut the RED/BLACK wire located in the wiring harness coming out of the
connector of the ignition key.
BONNET SWITCH Install an additional switch on the front headlamps bulkhead, above the
passenger s side headlamp.
DOORS SWITCH Connect to the BROWN/BLACK wire at the position nr. 1, in the 5 way black
connector located on the left connectors holder bracket, under the steering wheel.
See diagram nr. 69.
BOOT SWITCH Connect to the BROWN/GREEN wire located in the wiring harness coming out of
the connector of the rear lamp.
skfab00gbb.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
FITTING DIAGRAM N° 69
To make the perimetric connection on
SKODA FABIA
Original central unit located
on the left under the steering
wheel
S5 red connector
Brown/blue
Position nr. 4
(Boot)
Diodes 1N4007
S4 brown connector
Orange/violet
Position nr. 6
(front left)
Violet/white
Position nr. 4
(front right
Black/grey
Position nr. 13
(rear left)
Black/green
Position nr. 3
(rear right)
Diodes 1N4007
BLUE/PINK
(from the antitheft)
To obtain the perimetrical protection you must follow the above diagram. Each bottons line
must be interrupted by means of diodes to avoid anomalous signals due to negative signals
coming from the operating central unit of the vehicle.
skfab00gbb.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual. [ Pobierz całość w formacie PDF ]

  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • blacksoulman.xlx.pl